Moffat MGH620B Manual do Utilizador descarregar pdf (Página 9)

Permanent Connection

In the case of a permanent connection, it is

necessary that you install a double pole switch

between the hob and the electricity supply

(mains), with a minimum gap of 3 mm.

between the switch contacts and of a type

suitable for the required load in compliance

with the current electric regulations.

The switch must not break the yellow and

green earth cable at any point.

Ensure that the hob supply cord

does not come into contact with

surfaces with temperatures higher

than 50 deg. C.

FO 0390



Electrical connections

Any electrical work required to install

this hob should be carried out by a

qualified electrician or competent

person, in accordance with the current

regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability

should these safety measures not be

observed.

This hob is designed to be connected to a

230-240V 50Hz AC electrical supply.

Before switching on, make sure the electricity

supply voltage is the same as that indicated

on the hob rating plate. The rating plate is

located on the bottom of the hob. A copy is

attached on the back cover of this book.

The hob is supplied with a 3 core flexible supply

cord without plug. A proper plug, provided with

a 3amp ASTA approved (BS 1362) fuse must

be fitted to the cord.

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

1. Connect the green and yellow (earth)

wire to the terminal in the plug which is

marked with the letter 'E' or the earth

symbol or coloured green and yellow.

The earth wire should be about 2 cm

longer than the neutral and live wires.

2. Connect the blue (neutral) wire to the

terminal in the plug which is marked with

the letter 'N' or coloured black.

3. Connect the brown (live) wire to the

terminal in the plug which is marked with

the letter 'L' or coloured red.

Upon completion there must be no cut, or stray

strands of wire present and the cord clamp

must be secure over the outer sheath.

A cut off plug inserted into a 13 amp socket

is a serious safety (shock) hazard. Ensure

that the cut off plug is disposed of safely.

Min. size

Cable/flex Cable / flex type Fuse

0.75 mm

2

H05 V2V2-F (T90) 3 A

Supply cable replacement

The cable used to connect the hob to the

electrical supply must comply to the

specifications given below.

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários